lexmark t430 fuser error

Lexmark T430 Fuser Error

A fuser error message displays on the printer’s control panel. The fuser unit is a component of the printer. It heats the fuser toner onto the page. The error depends on the error code displayed on the control panel. It can be due to a bad fuser lamp or not getting enough power supply to it. If the fuser unit is overheating, the issue may occur. Check if there is a failure in the connection. Replacing the fuser unit is necessary if the Lexmark t430 fuser error persists.

What Is The Solution To Resolve The Fuser Error?

  1. Power off the printer and turn it back on.
  2. Lift the access door and remove the jammed paper.
  3. Check if the power cable is connected straight to a wall outlet.
  4. Locate the jammed paper in the fuser unit.
  5. Remove them if any.
  6. Resetting the printer may help to fix the printer issue.
  7. Do not expose the printer to cold temperature.
  8. Try to connect the Lexmark printer to a different wall outlet.
  9. Take the old unit out of the printer and replace it with a new one.
  10. A voltage trip can also be the reason for the fuser issue.
lexmark t430 fuser error

A Detailed Explanation For Resolving The Fuser Error

Step 1: The Lexmark t430 fuser error occurs due to the Low heat error. When the temperature of the printer goes down, the error happens. The LCD displays on the printer’s control panel. It can be a power issue. Check if the power source is working properly.

Step 2: Switch off the printer with the help of the Power button. Keep the printer in the inactive state for more than ten seconds before turning it on. If the issue continues, move to the next step to fix it.

Step 3: Plug in the power cable straight to the wall outlet. If many devices are connected, the problem may occur. Verify the temperature of the fuser unit. Take the fuser unit from the outlet. Check the thermostat and heat roller.

Step 4: Take the thermostat components of the fuser unit and clean them. Ensure that it is secure with the roller. Check the electronic contacts on the sides of the heat roller. Clear the contacts and then try to print. The open heat error happens after the printer warms up with a temperature of less than 60 degrees.

Step 5: If the Lexmark t430 fuser error occurs, power off the printer with the help of the Power button. Refrain from proceeding for at least 10 minutes. Check if the printer is in the Ready state. If the printer stops printing, try to follow the next step.

Step 6: If the device does not provide power, turn it off. Lift the left-hand access door and look for a sheet of jammed paper in the fuser unit. Take the torn papers out of the printer and then turn it on again. Verify if the power cable is connected correctly.

Step 7: If the issue persists, power off the printer. Raise the left side access door and take the fuser unit out of the printer. Check the inside the fuser unit for jammed papers. If there is any jammed paper is present in the fuser unit, take it out of the printer and reinstall it, and then try to print.

Step 8: If the black plastic tab on the left side of the access door is damaged, lift the door and locate the plastic tab. If the tab is damaged, it is necessary to replace it with a new one. The other issue with the Lexmark t430 fuser error occurs due to an open circuit issue in the thermostat circuit.

shares
HP Printer Guidelines