HP Envy 5070 is an All-in-One printer that can print, scan, and copy. The HP envy 5070 setup is very simple if you follow the quick steps given on this page.

HP Envy 5070 Setup
  • You have to unpack the printer from the product box and take out the printer supplies.
  • Remove all the protective tapes and covers from the printer.
  • Next, connect your printer to an electrical outlet using the supplied power cord and turn on the printer.
  • Navigate to the printer’s control panel and choose your desired language.
  • Tap Yes to confirm and set the date & time.
  • Raise the ink cartridge access door and wait until the carriage moves to the idle position.
  • Unpack the ink cartridges and remove the plastic tape from the nozzle output area.
  • Avoid touching the nozzle area with your hands to prevent poor print quality.
  • Go to the ink cartridge slot and lift the lid.
  • Install the color ink cartridge on the left and the black ink cartridge on the right of the ink cartridge slot.
  • Close the lid to secure the ink cartridges into its place and lower the ink cartridge access door.
  • Next, you have open the input tray and load a stack of legal plain paper into the tray after fanning them.
  • Adjust the loaded paper with the paper width guides and push the tray back into the printer.
  • Pull out the paper tray extender and tap Done on the printer’s control panel to print the alignment page.
  • Use the alignment page to align the ink cartridges and tap OK.
  • Finally, install the printer software on your computer after downloading a compatible printer driver from the official HP site.
  • Once you have completed the driver installation, verify the printer functionality by printing a test page. And finish the HP envy 5070 setup.

Fix Printer Problems

hp printer repair
hp printer software update
hp printer technical support