how to refill lexmark 100xl ink cartridge

How To Refill Lexmark 100XL Ink Cartridge

If the ink or toner in the cartridge is empty or low, then you will either replace the cartridge or refill the cartridge such that the printer prints well with no troubleshooting issues. When you refill the Lexmark’s cartridge, you have to reset the chip so that the printer identifies that the cartridge has been refilled. When you start the process of how to refill Lexmark 100xl ink cartridge, then you should be more careful, so that it doesn’t leak by its sides. So, have a towel or any cloth on a flat surface before refilling the cartridge.

Quick Steps For Refilling Lexmark 100XL Ink Cartridge

  1. Keep the cartridge on towels or any other cloth on the surface.
  2. Remove the cartridge’s top label.
  3. Fill the syringe with ink depending upon the cartridge capacity.
  4. Handle it carefully in order to avoid any spills.
  5. Inject the ink carefully in one of the holes if it is a single color cartridge.
  6. Decide which ink should be used for which cartridge in case of tri-color cartridges.
  7. Fill the ink in the holes correspondingly.
  8. Place the cartridge back in the printer.
how to refill lexmark 100xl ink cartridge

Detailed Steps For How To Refill Lexmark 100XL Ink Cartridge

Step 1: If the ink in the cartridge is empty or low, refill the cartridge with ink. When you refill the cartridge, you should also reset the chip so that the printer knows that the cartridge has been refilled.

Step 2: Place the cartridge on paper towels. Peel off the cartridge’s top label.

Step 3: There is only one label on the cartridge, so you shouldn’t have a problem locating it.

Step 4: Now, fill the syringe with about 25 ml of ink if it is a black cartridge or approximately 15 ml of ink if it is a color cartridge. The amount of ink depends on the cartridge capacity.

Step 5: If you are refilling a single-color cartridge, inject the ink slowly in one of the holes underneath the label you peeled off.

Step 6: You can inject in any hole because they all go to the same sponge. Now, after refilling the ink, you may leave the top label off. Its absence doesn’t affect the printing quality.

Step 7: If the printer uses a tri-color cartridge, you need to determine which hole leads to which ink, i.e., magenta, cyan, or yellow.

Step 8: Usually the top label on the cartridge, that you peeled off, tells which hole leads to which color compartment.

Step 9: If you are not sure, take a long needle or a toothpick and insert into each hole before you refill.

Step 10: Now, when you take the needle out, it will be colored, and so you will be able to determine which ink to fill in the hole. For more information regarding how to refill Lexmark 100xl ink cartridge, start connect with our tech experts now.

shares
hp printer technical support