how to refill Epson 288 ink cartridges

How To Refill Epson 288 Ink Cartridges | Quick Steps

Know how to refill Epson 288 ink cartridges, get a refillable cartridge and they have an auto-reset chip which will reset automatically. Also, they have a built-in refill ports such that they are much easier to refill when compared to other cartridges.

Short Steps To Refill Epson 288 Ink Cartridges

  1. Seal off the hole on the bottom of the ink cartridge with tape. And, the vent hole is the smaller hole on the opposite side of the ink outlet.
  2. Drill a small hole on the button.
  3. Fill the syringe half way and insert into the hole.
  4. Use a hot glue gun between the needle and the syringe. Now the whole cartridge is airtight.
  5. Draw the syringe upward & the air in the cartridge will bubble up.
  6. Release the syringe & ink will flow into the cartridge. Repeat until the cartridge is full and seal the hole with a hot glue gun.
  7. Repeat the steps till the colors have been filled. Place the tape over the top of the cartridge such that it covers every hole.
  8. Reinstall the printer and run the cleaning cycles till the cartridge starts to print properly.
how to refill Epson 288 ink cartridges

Brief Steps For Refilling Epson 288 Ink Cartridges

Lets start with how to refill Epson 288 ink cartridges, reset the chip by using a chip resetter. Drill a hole on the top of the Push button. Attach the needle to the syringe and load the syringe with ink. Insert needle in to the hole. Ensure that the needle reaches the bottom of the cartridge.

Slowly inject the ink into the cartridge. Stop if the ink starts coming up from the fill hole. Do not overfill.

Repeat the steps until all the colors have been filled. Place the tape over the top of the cartridge so that it covers every hole.

Reinstall the printer & run one or two cleaning cycles till the cartridge begins to print correctly. Then, do not exceed three cleaning cycles. Also, seal off the vent hole on the bottom of the cartridge with tape. Then, the vent hole is the smaller hole on the opposite side of the ink outlet to refill Epson 288 ink cartridges.

Drill a tiny hole on the Push button. Fill the syringe half way & insert in to the hole. Use a hot glue gun between the needle & the syringe. The whole cartridge is airtight now. Draw the syringe upward & the air in the cartridge will bubble up. Release the syringe & the ink will flow into the cartridge. Repeat until the cartridge is filled. And, seal the hole with a hot glue gun.

Repeat the steps till all the colors have been filled. Place the tape over the top of the cartridge so that it covers every hole.

Reinstall the printer & run one or two cleaning cycles till the cartridge begins to print correctly. Make sure not to exceed three cleaning cycles and completed on how to refill Epson 288 ink cartridges.

shares
hp printer technical support