epson error code 031008

How To Resolve Epson Error Code 031008

Epson error code 031008 displays on the printer’s control panel. It mainly occurs due to the improper installation of printhead or ink cartridges into their slots. Dust or debris on any of the above-mentioned components may lead to this issue.

Quick steps to resolve the Epson error code 031008

  1. Reboot the printer and the system.
  2. Clean and reset the ink cartridge of the printer.
  3. Uninstall and reinstall the printhead into the Epson printer.
  4. Check if the cartridge used is compatible with the printer model.
  5. Use a clean cloth to remove the dust on the ink cartridge.
  6. Do not leave the cartridge open for more than 30 minutes.
  7. Check if the cartridge is installed properly into the printer.
  8. Try to print from the printer to verify if the issue is resolved.
epson error code 031008

Brief solutions to resolve the Epson error code 031008

The error code 031008 can create a pause in the printing session. The main solution to resolve the issue is rebooting the printer. Remove the power cable from the power outlet of your wall. Long-press the Power button for at least 60 seconds.

After a while, replug the power cable. Release the button after printer turns on. Try to print a test page from the printer. If the issue persists, reset the printer to default settings with the help of the printer’s control panel.

Long-press the Resume button for 10 to 20 seconds to reset the printer to default settings in the printer’s control panel. Tap OK and release the key.

Try to print a test page from the printer. If the issue is unresolved, the cause can be due to the printhead or ink cartridges.

Press the Power button to enable its function. Detach all power cables connected to the printer. Raise the cartridge cover and take the ink cartridge out of its slots. Use a clean cloth to wipe the dust or debris on the cartridge.

Reinstall the ink cartridges into their slots. Touch the Reset button against the chip contacts on the cartridge after a while. A stable red light blinks on the printer’s control panel indicating a strong communication between the printer and the system.

Long-press the Reset button for a few minutes until the green LED light starts blinking.

You can clean the printhead using an automatic or manual process. Use the steps mentioned below to start the manual cleaning process.

Uninstall the printhead by raising the latch. After a while, clean its contacts and reinstall it.

Try to print from the printer to check if the Epson Error Code 031008 does not display on the printer’s control panel.

shares